CSEC Technical Drawing Paper 2 May/June 2023 - Free CXC Past Paper with Answers

Figure 1, on the enclosed sheet, shows an outline of a line drawing of the floor plan of a community centre. The community centre has one large meeting room, one conference room, one activity room, a kitchen, a storage room, an office, a reception hall and bathrooms.

Standard drawing practices and conventions for producing working drawings are to be followed.

Specifications for floor plan

Walls:

External — concrete blocks (150 mm thick)
Internal — concrete blocks (150 mm thick)

Doors:

Exterior doors — solid panel (2000 mm high $\times$ 910 mm wide)
Interior doors — solid panel (2000 mm high $\times$ 810 mm wide)

Window size:

Single hung sash — 1780 mm high $\times$ 1120 mm wide (single hung sash)

Draw, to a scale of 1:50, the completed floor plan of the community centre, using appropriate building conventions.

The drawing should include the following components:

Internal and external walls

All windows and doors

Kitchen sink, cupboards, and counters

Bathroom fixtures (toilets and sinks)

Label your drawing with the name of EACH room.

Show SIX main dimensions which MUST include an overall dimension, a room dimension, a door dimension and a window dimension.

Print a suitable title and the scale used.

Draw, to a scale of 1:10, a cross section of the ridge detail at "A" shown in Figure 1 on the enclosed sheet.

The drawing should include the following components:

Sheet board (plywood)

Ridge rafter (ridge board)

Label EACH component.

Print a suitable title and the scale used.

Specifications for ridge detail

Roof covering:

Metal sheets on 50 mm laths/purlins

Sheet board (plywood):

75 mm thick

Ridge rafter:

50 $\times$ 200 mm

Rafter:

50 $\times$ 150 mm

SECTION II – SKETCH AND DESIGN Do NOT spend more than 30 minutes on this section.

Make neat, proportional orthographic sketches of the following FOUR window types, indicating the swing OR the sliding direction:

Label EACH window type.

NOTE Candidates will be awarded marks for

proportion and neatness.

CSEC Technical Drawing Paper 2 May/June 2023 Questions

Question 1 (61 marks)

Specifications for floor plan

Specifications for ridge detail

Question 2 (27 marks)