CSEC Technical Drawing Paper 2 May/June 2026 - Free CXC Past Paper with Answers

Figure 1, on the enclosed sheet, shows the outline of a building (A) and the proposed site for an after-school centre (B).

NOTE

Standard drawing practices and conventions for producing working drawings are to be followed.
The corner labelled "X" on Figure 1 is the building set out point and MUST be located at 5200 mm from the edge of the road and 8500 mm from the west boundary/property line.

Specifications for the site plan Eave line/building overhang: 600 mm Front setback: 5200 mm from edge of road Side setbacks: 8500 mm from side property line

Using the outline of the building (A), draw the site plan to a scale 1:100 showing the location of the building (B), in accordance with the given setbacks.

Draw and label the following components.

Boundary lines/property lines
Building line
Setbacks
Septic pipes, septic tank and soakaway pit/suck well
Direction of flow for drainage of surface water
Eave line/ building overhang
North symbol
Identify the street
Driveway, walkway and parking

Show dimensions for the following.

Setbacks
Boundary lines

Print a suitable title and the scale used.

Figure 2, on the enclosed sheet, shows the plan of a straight flight of reinforced concrete stairs.

Make a neat and proportional orthographic sectional sketch at "A-A". Draw and identify EACH of the components given below.

Treads
Nosing
Risers
Landings
Steel

NOTE Candidates will be awarded marks for neatness and proportion.

CSEC Technical Drawing Paper 2 May/June 2026 Questions

Question 1 (90 marks)

Question 2 (30 marks)